Home> Products> >M.2 SSD

M.2 Solid State Drive

Viking Technology’s M.2 SSD Solid State Drive (SSD) is a high-performance, high-capacity flash solution optimized for the embedded and server market.

The M.2 SSD is a caseless drive with either a SATA or Gen 3 PCIe/NVMe connector, delivering high-bandwidth READs and WRITEs at a fraction the size of a standard 2.5 inch SSD. The thin form factor comes in variety of sizes best fit to the customer’s system requirements, ranging from 40mm to 110mm in length. Viking's M.2 SSD features intelligent flash management techniques to optimize endurance and wear-leveling, as well as best in class performance.


  • Best in class sequential and random performance
  • MLC capacities up to 1TB
  • Advanced SSD-specific SMART command support
  • Intelligent write management techniques for optimized endurance
  • Built-in AES-256 encryption for secure data protection
  • TRIM command support
MLC  Up to 512GB Up to 1TB
Sustained Read / Write 540 MB/s 540MB/s
Sustained Random Read & Write IOPS Up to 60,000 IOPS Up to 100,000 IOPS
Interface SATA 6Gb SATA 6Gb
ECC 55bit / 512 BCH  
Bit Error Rate (BER) <1 in 1017 bits read
Power Fail Data Protection Yes
Tiered Error Protection Data recovery from sector, page, and block failure. End-to-End CRC protection
Temperature Monitoring On-board sensor, S.M.A.R.T. Attribute
Shock 50g, 11ms, 3 shocks applied in each direction on 3 mutually perpendicular axis
Vibration 16.4g rms 10 - 2,000 Hz, 3 axis
Operating Temperature 0°C to 70°C  
Industrial Temperature -40°C to 85°C
Altitude 80,000 feet
Humidity 5% to 95%, non-condensing, relative
Safety / Agency / Compliance FCC, CE, TUV
Power Voltage 3.3V +5%  
Active <3.3 Watts
Idle 0.9 Watts
Form Factor M.2  
Length 22mm (width) x 42, 60, 80, 110mm (length) x 3.87mm (height)


Specification Sheet

Email to a Friend

Infographic & Comparison Charts  Contact and Support

Specification Sheet


Contact and Support